AGFA CR 30-X - 4 Added Ground Connection for Front Cover; 5 Modified Safety Brackets for Prescan Roller; 6 Modified segmented Transport roller and Added Erasure Unit Guide Plate

DD+DIS147.08E
Manufacturing Standard Modifications
DOCUMENT CONTROL NOTE:
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 0 CR 30-X Chapter 8 / 6
05-2008 Type 5175 /100/110 Agfa Company Confidential
4 Added Ground Connection for Front Cover
Reason
Improvement of overall ESD (electrostatic discharge) behaviour of
the digitiser.
Product(s) &
Serial
Number(s)
Digitizer type 5175/100: SN ≥ 1610
Part
Number(s)
Not available as spare part, only available as part of Service Kit
CM+9 5175 9130 0.
Referenced
Document(s)
Service Bulletin # 12, DD+DIS148.07E
5 Modified Safety Brackets for Prescan Roller
Reason
To prvent that prescan rollers fall off during transport.
Product(s) &
Serial
Number(s)
Digitizer type 5175/100: SN ≥ 1633
Part
Number(s)
Not available as spare part, only available as part of Service Kit
CM+9 5175 9130 0.
Referenced
Document(s)
Service Bulletin # 12, DD+DIS148.07E
6 Modified segmented Transport roller and Added Erasure Unit
Guide Plate
Reason
Improvement of IP run reliability.
Product(s) &
Serial
Number(s)
Digitizer type 5175/100: SN ≥ 1568 plus 1495
Part
Number(s)
Not available as spare part, only available as part of Service Kit
CM+9 5175 9130 0.
Referenced
Document(s)
Service Bulletin # 12, DD+DIS148.07E