190 Rockwell Automation Publication 1769-UM022C-EN-P - June 2018
Chapter 13 Store and Load Programs with a Secure Digital Card
Follow these steps to store a project.
1. Go online with the controller.
2. Put the controller in Program mode, that is, Remote Program or
Program.
3. On the Online tool bar, click the controller properties icon.
4. Click the Nonvolatile Memory tab.
5. Click Load/Store.
TIP If Load/Store is dimmed (unavailable), verify the following:
• You have specified the correct communication path and are online with
the controller.
• The SD card is installed.
If the SD card is not installed, a
message in the lower-left corner of
the Nonvolatile Memory tab
indicates the card is missing.
To Next Page
Loading...
Need help?
General
