Rockwell Automation Publication 1769-UM022C-EN-P - June 2018 57
Configure the Controller Chapter 4
7. From the Revision pull-down menu, choose the major revision of
firmware for the controller.
8. From the Security Authority pull-down menu, choose a security
authority option.
For detailed information on security, refer to the Logix 5000™
Controllers Security Programming Manual, publication 1756-PM016
.
9. Check the box below Security Authority if you want to use the selected
protection for authentication and authorization.
10. In the Description field, enter a description of the project.
11. Click Finish.
The Logix Designer application creates a safety task and a safety program. A
main ladder logic safety routine called MainRoutine is also created within the
safety program.
Figure 3 - Safety Task in the Controller Organizer
A red bar under the icon distinguishes safety programs and routines from
standard project components in the Controller Organizer.
When a new safety project is created, the Logix Designer application also
automatically creates a time-based safety network number (SNN).
To Next Page
Loading...
