ARAG DELTA 80 - Page 117

117
MESSAGE ON DISPLAY CAUSE REMEDY JOB MODE
Invalid signal of the pressure sensor!
Signal from pressure sensor is out of allowed
range
• Check the sensor and connection cable (and
connector) status (par. 6.6)
--
Decelerate!
Pressure too high
The pressure exceeds the maximum level
allowed for the nozzle being used
• Decrease driving speed
• Adjust the operating pressure so as to respect
the previously set limits for nozzles in use.
• Check set maximum pressure for nozzles in use
(par. 10.1.7)
Master ON
Accelerate!
Insufficient pressure
The pressure does not reach the minimum value
for the nozzle in use
• Increase driving speed
• Adjust the operating pressure so as to respect
the previously set limits for nozzles in use.
• Check set minimum pressure for nozzle in use
(par. 10.1.7)
Master ON
Flowmeter out of range!
Rate out of the limits allowed by owmeter
• Modify working conditions to suit owmeter limits
(speed, pressure, etc.)
• Make sure that owmeter parameters are set
correctly (par. 10.1.3)
Master ON
Decelerate!
Insufficient flowrate
Flowrate does not reach the value requested
for output
• Decrease driving speed
• Make sure that owmeter parameters are set
correctly (par. 10.1.3)
Master ON
+
Automatic
adjustment ON
Accelerate!
Too high flowrate
The owrate exceeds the value required for
output
• Increase driving speed
• Make sure that settings in the Implement
advanced settings menu (boom width,
owmeter, etc. chap. 10.1) are set correctly
Master ON
+
Automatic
adjustment ON
Reduce rotation speed!
RPM exceeds the maximum set value
• Decrease the rotation speed of the moving part
• Check the constant set for the rev counter
(par. 10.1.9)
--
Increase rotation speed!
RPM does not reach the minimum value
• Increase the rotation speed of the moving part
• Check the constant set for the rev counter
(par. 10.1.9)
Master ON
Check nozzles wear status!
Difference between measured and calculated
owrate (according to selected nozzle data)
higher than set value
• Check that the set nozzle coincides with the one
installed on the boom (par. 10.1.1)
• Replace nozzles
Master ON
+
Automatic
adjustment ON
CONTINUES
MAINTENANCE / DIAGNOSTICS / REPAIRS