Argo S - Page 356

Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
Argo Service Manual Transmission
TR-17
Transmissions manufactured from Oct of 2000 have had a design change to the Side
Cover. This new Side Cover begins on vehicles manufactured from serial numbers:
SN11905 TB Oct. 4/00
S11906 TB Oct. 4/00
BF11917 OB Oct. 10/00
CB17471 YB Oct. 12/00
RB17525 TB Oct. 24/00
This Side Cover no longer requires the 31-07 plug or the 106-01 Retaining Ring. The
Side Cover has been cast and machined in this area to eliminate the need for both of
these parts. The cover will replace all earlier side covers. Photo TR-40 The
procedure for removing the 101-01 Bearings will require the use of an internal style
of puller as described below.
IMPORIMPOR
IMPORIMPOR
IMPOR
TT
TT
T
ANTANT
ANTANT
ANT
30. Place the Side Cover into the assembly
fixture with the Bearings facing up.
Photo TR-41
31. Adjust the internal bearing puller to the
closed position. Photo TR-42
32. Insert the bearing puller into the inner
race of the 101-01 bearing and tighten
the adjustment nut until the puller has
spread enough to secure the bearing
from the inside. Photo TR-43
TR-40 TR-41
TR-42