Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
Transmission Argo Service Manual
TR-34
21. Place a Ball Bearing to the top of the
spring. Photo TR-108 & 109
22. Compress the Ball Bearing into the hole of the Double Gear with a flat screwdriver,
at the same time inserting the Spline Shaft from the opposite side with the shift gate
notches facing down. These notches will mate with the Ball Bearing within the
Double Gear when the shifter assembly is completed. Photo TR-110, 111 & 112
(following page.)
TR-105 TR-106
TR-107 TR-108
TR-109
To Next Page
Loading...
