Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
TR-18A
Transmission Argo Service Manual
Use a specialized spacing tool to secure the
previously installed 101-15 Bearing inside
the Aluminum Cage while the Output Shaft
is press into place. Photo TR-64
TR-64
7. Orient the 34-14 Sun Gear as in Photo
TR-65 with the higher shoulder side fac-
ing up. Install it to the splined end of
the Output Shaft. Photo TR-66 & 67
8. Secure the Sun Gear with a 107-04 Snap Ring. Photo TR-68
TR-65
TR-66
TR-67 TR-68
9. Be sure the Retaining Ring is properly seated to the machined groove of the Output
Shaft. Photo TR-69 Press the Output Shaft from the inside of the cage to seat the
Retaining Ring snuggly against the Sun Gear. Photo TR-70
To Next Page
Loading...
