Syntax:
no interface <port-list> lacp
Removes <port-list> from any dynamic LACP trunk and returns the ports in <port-list> to passive
LACP.
Example:
Port C6 belongs to an operating, dynamic LACP trunk. To remove port C6 from the dynamic trunk and return it to
passive LACP, do the following:
switch(config)# no interface c6 lacp
switch(config)# interface c6 lacp passive
In the above Example:, if the port on the other end of the link is configured for active LACP or static LACP, the
trunked link will be re-established almost immediately.
Viewing existing port trunk groups (WebAgent)
While the WebAgent does not enable you to configure a port trunk group, it does provide a view of an existing
trunk group.
To view any port trunk groups:
1. In the navigation pane, click Interface.
2. Click Port Info/Config. The trunk information for the port displays in the Port Properties box.
Trunk group operation using LACP
The switch can automatically configure a dynamic LACP trunk group, or you can manually configure a static
LACP trunk group.
NOTE: LACP requires full-duplex (FDx) links of the same media type (10/100Base-T, 100FX, and so
on) and the same speed and enforces speed and duplex conformance across a trunk group. For
most installations, HPE Switch recommends that you leave the port mode settings at Auto (the
default). LACP also operates with Auto-10, Auto-100, and Auto-1000 (if negotiation selects
FDx), and 10FDx, 100FDx, and 1000FDx settings.
LACP trunk status commands include:
Trunk display method Static LACP trunk Dynamic LACP trunk
CLI show lacp command Included in listing. Included in listing.
CLI show trunk command Included in listing. Not included.
Port/Trunk Settings screen in menu interface Included in listing. Not included
Thus, to display a listing of dynamic LACP trunk ports, you must use the show lacp command.
In most cases, trunks configured for LACP on the switches operate as described in the following table.
116 Aruba 2530 Management and Configuration Guide for
ArubaOS-Switch 16.05
To Next Page
Loading...
