Aruba 2530 - Device-Profile Name

------ ---------------------- ---------- -------
1 abc a1b2c3 2
device-profile name
Syntax
[no] device-profile name <PROFILE-NAME> [untagged-vlan <VLAN-ID> |
tagged-vlan <VLAN-LIST> |
cos <COS-VALUE> |
ingress-bandwidth <Percentage> |
egress-bandwidth <Percentage> |
{poe-priority {critical | high | low} |
speed-duplex {auto | auto-10 | auto-100 | ...} |
poe-max-power <Watts>]
Description
This command is used to create an user-defined profile. A profile is a named collection of port settings applied as
a group. You can modify the default profile, default-ap-profile, but you cannot delete it. You can create four
additional profiles.
The default-ap-profile has the following values:
• untagged-vlan: 1
• tagged-vlan: None
• ingress-bandwidth: 100
• egress-bandwidth: 100
• cos: 0
• speed-duplex: auto
• poe-max-power: 33
• poe-priority: critical
You can modify these parameters. For example, you can execute no untagged-vlan to create a device profile
with tagged only ports.
Parameters
name
Specifies the name of the profile to be configured. The profile names can be at most 32 characters long.
cos
The Class of Service (CoS) priority for traffic from the device.
untagged-vlan
The port is an untagged member of specified VLAN.
tagged-vlan
The port is a tagged member of the specified VLANs.
ingress-bandwidth
The ingress maximum bandwidth for the device port.
egress-bandwidth
Chapter 11 Auto configuration upon Aruba AP detection 245