EasyManua.ls Logo

Aruba 2530 - Event Log; Restrictions

Aruba 2530
479 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
------ ----- + ------ ----------- ------------------- ---------- ------------
A1 Yes Down Low warn-and-disable 65535 45303
A5 No Up None None - -
A22 Yes Down Low warn-and-disable - -
A23 Yes Down High warn-and-disable 100 -
NOTE: This example displays only the list of ports configured via the above per-port config
commands, does not include the global configuration ports.
Event Log
Cause
Message Cause
FFI: port <ID>- Excessive link state transitions. Link-flap is detected by fault-finder per the sensitivity
configured.
FFI: port <ID>- Excessive link state
transitions.FFI: port <ID>-Port disabled by
Fault-finder.FFI: port <ID>-Administrator action
is required to re-enable.ports: Fault-finder (71)
has disabled port <ID>.ports: port <ID> is now
offline.vlan: VLAN<VLAN-ID> virtual LAN is
disabled.
Link-flap is detected and the action is to disable the port with
no disable timer.
FFI: port <ID>- Excessive link state
transitions.FFI: port <ID>-Port disabled by
Fault-finder.ports: Fault-finder(71) has disabled
port <ID> for <SECONDS> seconds.ports: port
<ID> is now off-line.vlan: VLAN<VLAN-ID>
virtual LAN is disabled.
Link-flap is detected and the action is to disable the port with
disable timer.
port <ID> timer (71) has expired.ports: port
<ID> is now on-line.vlan: VLAN<VLAN-ID>
virtual LAN is enabled.
The port is enabled when the disable timer expires.
Restrictions
Per port configuration for options – link-flap only. Global settings for other options.
No support for menu interface.
No support for Web UI.
No support for trunks.
Chapter 7 Fault-Finder port-level link-flap 143

Table of Contents

Related product manuals