Aruba 2530 - Device-Profile Type

The egress maximum bandwidth for the device port.
poe-priority
The PoE priority for the device port.
speed-duplex
The speed and duplex for the device port.
poe-max-power
The maximum PoE power for the device port.
Options
no
Removes the user-defined profiles.
Restrictions
• You can modify the configuration parameters of the default profile, default-ap-profile, but you cannot
delete it or change its name.
• For Aruba 5400R Switch Series and Aruba 2930F Switch Series devices, the maximum value for poe-max-
power is 30 W. For all other devices, the maximum value for poe-max-power is 33 W.
• Egress rate limiting is not supported for devices running on:
◦ Aruba 2530 Switch Series
◦ Aruba 2540 Switch Series
◦ Aruba 2930F Switch Series
• The egress-bandwidth is only supported for Aruba 2920 and Aruba 5400R Switch Series v2 & v3.
• The egress-bandwidth option is not supported and not displayed in the CLI for the Aruba 2530 switch.
• The profile configuration is only applicable to access points.
device-profile type
Syntax
device-profile type <DEVICE> [associate <PROFILE-NAME> | enable | disable ]
Description
This command specifies an approved device type in order to configure and attach a profile to it. The profile’s
configuration is applied to any port where a device of this type is connected.
Parameters
type
An approved device type in order to configure and attach a profile to it. The only device type supported is aruba-
ap and it is used to identify all the Aruba APs.
APs.
associate
Associates a profile with a device type.
enable
246 Aruba 2530 Management and Configuration Guide for
ArubaOS-Switch 16.05