Aruba 2530 - Timesync Ntp; Ntp; [No] Ntp

sntp
Updates the system clock using SNTP.
timep-or-sntp
Updates the system clock using TIMEP or SNTP (default).
ntp
Updates the system clock using NTP
Example
switch(config)# timesync
sntp Update the system clock using SNTP.
timep Update the system clock using TIMEP.
timep-or-sntp Update the system clock using TIMEP or SNTP.
ntp Update the system clock using NTP.
timesync ntp
This command is used to update the system clock using NTP.
Syntax
timesync ntp
Description
Update the system clock using NTP.
ntp
This command selects the operating mode of the NTP client.
Syntax
ntp [broadcast|unicast]
Options
broadcast
Sets ntp client to operate in broadcast mode.
unicast
Sets ntp client to operate in unicast mode.
Usage
The default mode is broadcast.
[no] ntp
This command disables NTP and removes all NTP configurations on the device.
Syntax
[no] ntp [authentication <key-id>
| broadcast | enable | max-association
<integer> | server
<IP-ADDR> | trap
<trap-name> | unicast]
40 Aruba 2530 Management and Configuration Guide for
ArubaOS-Switch 16.05