Aruba 2530 - Ntp Ipv6-Multicast; Debug Ntp

burst
Enables burst mode.
iburst
Enables initial burst (iburst) mode.
key-id
Set the authentication key to use for this server.
max-poll <max-poll-val>
Configure the maximum time intervals in seconds.
min-poll <min-poll-val>
Configure the minimum time intervals in seconds.
ntp ipv6-multicast
This command is used to configure NTP multicast on a VLAN interface.
Syntax
ntp ipv6-multicast
Description
Configure the interface to listen to the NTP multicast packets.
Example
Switch(vlan-2)# ntp
ipv6-multicast Configure the interface to listen to the NTP multicast packets.
Restrictions
Validation Error/Warning/Prompt
If ipv6 is not enabled on vlan interface
IPv6 address not configured on the
VLAN.
debug ntp
This command is used to display debug messages for NTP.
Syntax
debug ntp <event |
packet>
Options
event
Displays event log messages related to NTP.
packets
Displays NTP packet messages.
Description
Enable debug logging. Use [no] to disable debug logging.
46 Aruba 2530 Management and Configuration Guide for
ArubaOS-Switch 16.05