Aruba 2530 - Viewing Poe When Using LLDP Information

NOTE:
If LLDP is disabled at runtime, and a PD is using PoE+ power that has been negotiated through
LLDP, there is a temporary power drop; the port begins using PoE+ power through the PLC. This
event is recorded in the Event Log. An Example: message would look like the following:
W 08/04/13 13:35:50 02768 ports: Port A1 PoE power dropped.
Exceeded physical classification for a PoE Type1 device (LLDP process
disabled)
When LLDP is enabled again, it causes a temporary power drop. This event is also recorded in the
Event Log. An Example: message looks like the following:
W 08/04/13 13:36:31 02771 ports: Port A1 PoE power dropped.
Exceeded physical classification due to change in classification type (LLDP
process enabled)
Viewing PoE when using LLDP information
Syntax:
show lldp config <port-list>
Displays the LLDP port configuration information, including the TLVs advertised.
LLDP port configuration information with PoE
switch(config)# show lldp config 4
LLCP Port Configuration Detail
Port : 4
AdminStatus [Tx_Rx] : Tx_Rx
NotificationsEnabled [False] : False
Med Topology Trap Enabled [False] : False
TLVS Advertised:
* port_descr
* system_name
* system_descr
* system_cap
* capabilities
* network_policy
* location_id
* poe
* macphy_config
* poeplus_config
IpAddress Advertised:
Local power information on page 96 shows an Example: of the local device power information using the show
lldp info local-device <port-list> command.
Local power information
switch(config)# show lldp info local-device A1
96 Aruba 2530 Management and Configuration Guide for
ArubaOS-Switch 16.05