Aruba 2530 - Error Messages Associated with the Show Interfaces Command

Parameter column Displays Examples
speed Connection speed and duplex 1000FDX
mode Configured mode auto, auto-100, 100FDX
mdi MDI mode auto, MDIX
flow Flow control on or off
name Friendly port name
vlanid The vlan id this port belongs to, or "tagged" if it
belongs to more than one vlan
4tagged
enabled port is or is not enabled yes or nointrusion
intrusion Intrusion alert status no
bcast Broadcast limit 0
The custom show interfaces command
switch(config)# show int custom 1-4 port name:4 type vlan intrusion speed enabled mdi
Status and Counters - Custom Port Status
Intrusion
Port Name Type VLAN Alert Speed Enabled MDI-mode
---- ---------- ---------- ----- --------- ------- ------- --------
1 Acco 100/1000T 1 No 1000FDx Yes Auto
2 Huma 100/1000T 1 No 1000FDx Yes Auto
3 Deve 100/1000T 1 No 1000FDx Yes Auto
4 Lab1 100/1000T 1 No 1000FDx Yes Auto
You can specify the column width by entering a colon after the column name, then indicating the number of
characters to display. In the above example, the Name column displays only the first four characters of the name.
All remaining characters are truncated.
NOTE: Each field has a fixed minimum width to be displayed. If you specify a field width smaller than
the minimum width, the information is displayed at the minimum width. For example, if the minimum
width for the Name field is 4 characters and you specify Name:2, the Name field displays 4
characters.
You can enter parameters in any order. There is a limit of 80 characters per line; if you exceed this limit an error
displays.
Error messages associated with the show interfaces command
The following table provides information on error messages associated with the show interfaces custom
command.
Chapter 3 Port Status and Configuration 61