Aruba 2530 - Unable to Enable Feature; Authenticated User Redirected to Login Page

2. Disabled the enabled authentication method found in step 1.
3. Run the aaa authentication captive-portal enable command.
Unable to enable feature
Symptom
One of the following messages is displayed:
• BYOD redirect cannot be enabled when captive portal is enabled.
• MAC authentication failure redirect cannot be enabled when captive
portal is enabled.
• Web-based authentication cannot be enabled when captive portal
is enabled.
•
V1 compatibility mode cannot be enabled when captive portal
is enabled.
Cause
You cannot enable these features when Captive Portal is already enabled. They are mutually exclusive.
Action
You can either disable Captive Portal or avoid enabling these features.
Authenticated user redirected to login page
Symptom
User is redirected back to the login page to submit credentials even after getting fully authenticated.
Solution 1
Cause
The status is not changed to Known.
Action
After the client submits the credentials, the CPPM service must change the Endpoint Status to Known.
Solution 2
Cause
The cache value is set.
218 Aruba 2530 Management and Configuration Guide for
ArubaOS-Switch 16.05