Aruba 2530 - Timep: Selecting and Configuring; Viewing, Enabling, and Modifying the Timep Protocol (Menu)

SNTP Mode : disabled
Poll Interval (sec) [720] : 600
IP Address Protocol Version
------------- -----------------
10.28.227.141 3
Note that even though the Time Sync Mode is set to Sntp, time synchronization is disabled because no sntp
has disabled the SNTP Mode parameter.
TimeP: Selecting and configuring
The following table shows TimeP parameters and their operations.
Table 2: TimeP parameters
TimeP
parameter
Operation
Time Sync
Method
Used to select either TIMEP, SNTP, NTP, or None as the time synchronization method.
TimeP Mode
Disabled TimeP does not operate, even if specified by the Menu interface Time Sync Method
parameter or the CLI timesync command.
DHCP When TimeP is selected as the time synchronization method, the switch attempts to acquire a
TimeP server IP address via DHCP. If the switch receives a server address, it polls the server
for updates according to the TimeP poll interval. If the switch does not receive a TimeP server
IP address, it cannot perform time synchronization updates.
Manual When TimeP is selected as the time synchronization method, the switch attempts to poll the
specified server for updates according to the TimeP poll interval. If the switch fails to receive
updates from the server, time synchronization updates do not occur.
Server
Address
Used only when the TimeP Mode is set to Manual. Specifies the IP address of the TimeP
server that the switch accesses for time synchronization updates. You can configure one
server.
Viewing, enabling, and modifying the TimeP protocol (Menu)
Procedure
1. From the Main Menu, select:
2. Switch Configuration
Chapter 2 Time Protocols 31