6. In the Poll Interval field, enter the time in minutes that you want for a TimeP Poll Interval.
7. Select [Enter] to return to the Actions line, then select [S] (for Save) to enter the new time protocol
configuration in both the startup-config and running-config files.
Viewing the current TimeP configuration (CLI)
Using different show commands, you can display either the full TimeP configuration or a combined listing of all
TimeP, SNTP, and VLAN IP addresses configured on the switch.
Syntax:
show timep
Lists both the time synchronization method (TimeP, SNTP, or None) and the TimeP configuration, even if SNTP is
not the selected time protocol. (If the TimeP Mode is set to Disabled or DHCP, the Server field does not appear.)
If you configure the switch with TimeP as the time synchronization method, then enable TimeP in DHCP mode
with the default poll interval, show timep lists the following:
TimeP configuration when TimeP is the selected Time synchronization method
switch(config)# show timep
Timep Configuration
Time Sync Mode: Timep
TimeP Mode [Disabled] : DHCP Server Address : 10.10.28.103
Poll Interval (min) [720] : 720
If SNTP is the selected time synchronization method, show timep still lists the TimeP configuration even though
it is not currently in use. Even though, in this Example:, SNTP is the current time synchronization method, the
switch maintains the TimeP configuration:
TimeP configuration when TimeP is not the selected time synchronization method
switch(config)# show timep
Timep Configuration
Time Sync Mode: Sntp
TimeP Mode [Disabled] : Manual Server Address : 10.10.28.100
Poll Interval (min) [720] : 720
Syntax:
show management
Helps you to easily examine and compare the IP addressing on the switch. It lists the IP addresses for all time
servers configured on the switch plus the IP addresses and default gateway for all VLANs configured on the
switch.
Display showing IP addressing for all configured time servers and VLANs
switch(config)# show management
Status and Counters - Management Address Information
Chapter 2 Time Protocols 33
To Next Page
Loading...
