6. Use the down arrow key to move the cursor to the Action column for the individual ports and position the
cursor at a port you want to monitor.
7. Press the Space bar to select Monitor for each port and trunk that you want monitored. (Use the down arrow
key to move from one interface to the next in the Action column.)
8. When you finish selecting ports to monitor, press [Enter], then press [S] (for Save ) to save your changes and
exit from the screen.
9. Return to the Main Menu.
Configuring port and static trunk monitoring (CLI)
You must use the following configuration sequence to configure port and static trunk monitoring in the CLI:
1. Assign a monitoring (mirror) port.
2. Designate the port(s) and/or static trunk(s) to monitor.
Displaying the monitoring configuration
Syntax:
show monitor
This command lists the port assigned to receive monitored traffic and the ports and/or trunks being monitored.
For example, if you assign port 5 as the monitoring port and configure the switch to monitor ports 2-4, show
monitor displays the following:
Monitored port listing
switch(config)# show monitor
Network Monitoring Port
Mirror Port: 4
Monitoring sources
------------------
2
3
4
• Port receiving monitored traffic.
• Monitored ports
Configuring the monitor port
Syntax:
[no] mirror-port [ <port-num> ]
This command assigns or removes a monitoring port, and must be executed from the global configuration level.
Removing the monitor port disables port monitoring and resets the monitoring parameters to their factory-default
settings.
304 Aruba 2530 Management and Configuration Guide for
ArubaOS-Switch 16.05
To Next Page