Aruba 2530 - Copying Command Output to a Destination Device (CLI); Copying Event Log Output to a Destination Device (CLI); Copying Crash Data Content to a Destination Device (CLI)

Flight data recorder (FDR) logs
Information that is “interesting” at the time of the crash, as well as when the switch is not performing correctly
but has not crashed.
The destination device and copy method options are as follows (CLI keyword is in bold):
• Remote Host via TFTP.
• Serially connected PC or UNIX workstation via Xmodem.
Copying command output to a destination device (CLI)
Syntax:
copy command-output <"cli-command"> tftp <ip-address> <filepath-filename>
copy command-output <"cli-command"> xmodem
Example:
To use Xmodem to copy the output of show config to a serially connected PC:
Figure 41: Sending command output to a file on an attached PC
NOTE: The command you specify must be enclosed in double quotation marks.
Copying Event Log output to a destination device (CLI)
Syntax:
copy event-log tftp <ip-address> <filepath_filename>
copy event-log xmodem <filename>
Example:
To copy the event log to a PC connected to the switch:
Figure 42: Sending event log content to a file on an attached PC
Copying crash data content to a destination device (CLI)
This command uses TFTP, USB or Xmodem to copy the Crash Data content to a destination device.
280 Aruba 2530 Management and Configuration Guide for
ArubaOS-Switch 16.05