Syntax:
copy crash-data tftp <ip-address> <filename>
copy crash-data xmodem
These commands copy the crash data content to a remote host, attached USB device, or to a serially connected
PC or UNIX workstation.
slot-id
a - h—Retrieves the crash log or crash data from the processor on the module in the specified
slot
mm
Retrieves crash log or crash data from the switch's chassis processor. When "mm" is specified,
crash files from both management modules are copied.
oobm
For switches that have a separate OOBM port, specifies that the transfer is through the OOBM
interface. (Default is transfer through the data interface.)
You can copy individual slot information or the management module (mm) switch information. If you do not specify
either, the command defaults to the mm data.
To copy the switch's crash data to a file in a PC:
Copying switch crash data content to a PC
switch(config)# copy crash-data xmodem pc
Press 'Enter' and start XMODEM on your host...
Transfer complete
At this point press [Enter] and start the Xmodem command sequence in your terminal emulator.
Chapter 14 File Transfers 281
To Next Page
Loading...
