Aruba 2530 - Debug Ztp; Stacking Support; Disabling ZTP

show running-configuration
switch# show running-config
hostname "switch-name"
module 1 type j9726a
snmp-server community "public" unrestricted
oobm
ip address dhcp-bootp
exit
vlan 1
name "DEFAULT_VLAN"
untagged 1-24
ip address dhcp-bootp
exit
amp-server ip 192.168.1.1 group "group" folder "folder" secret "branch1024"
debug ztp
Syntax
debug ztp
no debug ztp
Description
Enables or disables ZTP debug logging.
Parameters and options
ztp
Zero Touch Provisioning.
no
The no debug ztp command disables ZTP debug logging.
Stacking support
The ZTP process for stacked switches with AirWave is similar to the one for the standalone switch, with the
exception that only the commander in the stack checks in with AirWave.
Disabling ZTP
ZTP is disabled if you make any of the following changes to the switch configuration:
• Enter the switch configuration mode using the configure terminal command.
• Enter into Menu and exit without doing any configuration
• Use CLI, SNMP, REST APIs, menu interface, or the web GUI to configure any settings. The change is shown
in the running-configuration of the switch.
• To upgrade with nonminimal configuration set from any 15.xx version to version 16.01, see Image Upgrade.
• Once DHCP server or Activate offers Airwave/Central details, ZTP is disabled. If the details are offered again,
it is ignored.
Chapter 10 Zero Touch Provisioning with AirWave and Central 237