Aruba 2530 - Operation Note

LLCP Local Port Information Detail
Port : A1
PortType : local
PortId : 1
PortDesc : A1
Pvid : 1
Poe Plus Information Detail
Poe Device Type : Type2 PSE
Power Source : Primary
Power Priority : low
PD Requested Power Value : 20 Watts
PSE Actual Power Value : 20 Watts
Remote power information on page 97 shows the remote device power information using the show lldp
info remote-device <port-list> command.
Remote power information
switch(config)# show lldp info remote-device A3
LLCP Remote Device Information Detail
Local Port : A3
ChassisType : mac-address
ChassisId : 00 16 35 ff 2d 40
PortType : local
PortId : 23
SysName : HPSwitch
System Descr : HP Switch, revision YA.14.xx
PortDescr : 23
Pvid : 55
System Capabilities Supported : bridge, router
System Capabilities Enabled : bridge
Remote Management Address
Type : ipv4
Address : 10.0.102.198
Poe Plus Information Detail
Poe Device Type : Type2 PD
Power Source : Only PSE
Power Priority : low
PD Requested Power Value : 20 Watts
PSE Actual Power Value : 20 Watts
Operation note
The advertisement of power with TLVs for LLDP PoE+ is enabled by default. If LLDP is disabled at runtime and a
PD is using PoE+ power that has been negotiated through LLDP, there will be a temporary power drop. The port
will begin using PoE+ power through the PLC. This event is recorded in the event log. An Example: message
would look like the following:
W 08/04/13 13:35:50 02768 ports: Port A1 PoE power dropped.
Exceeded physical classification for a PoE Type1 device
(LLDP process disabled)
Chapter 4 Power Over Ethernet (PoE/PoE+) Operation 97