Aruba 2530 - Show Fault-Finder Link-Flap

Configure ports for link-flap detection with high sensitivity
Configure ports A1 to A5 for link-flap detection with sensitivity of high (3 flaps over 10s) and to log and disable
port for 65535s if the link-flap threshold is exceeded.
switch(config)# fault-finder link-flap ethernet A1-A5 action warn-and-disable 65535
sensitivity high
Configure ports for link-flap detection with medium sensitivity
Configure ports A8 for link-flap detection with sensitivity of medium (6 flaps over 10s) and to log and disable port if
the link-flap threshold is exceeded. User will need to re-enable the port if disabled.
switch(config)# fault-finder link-flap ethernet A8 action warn-and-disable 0 sensitivity medium
Configure ports for link-flap detection with low sensitivity
Configure ports A22 for link-flap detection with sensitivity of low (10 flaps over 10s) and to log if the link-flap
threshold is exceeded
switch(config)# fault-finder link-flap ethernet A22 action warn sensitivity low
Disable link-flap detection
Disable link-flap detection for port A5
switch(config)# no fault-finder link-flap ethernet A5
Show fault-finder link-flap
Syntax
show fault-finder link-flap ethernet PORT-LIST
Description
Display the link-flap control configuration.
Show fault-finder link-flap
switch# show fault-finder link-flap A1
Link | Port Disable Disable Time
Port Flap | Status Sensitivity Action Timer Left
------ ----- + ------ ----------- ------------------ ---------- ------------
A1 Yes Down Low warn-and-disable 65535 45303
switch# show fault-finder link-flap
Link | Port Disable Disable Time
Port Flap | Status Sensitivity Action Timer Left
142 Aruba 2530 Management and Configuration Guide for
ArubaOS-Switch 16.05