Viewing sFlow Configuration and Status (CLI)
The following sFlow commands allow you to display sFlow configuration and status via the CLI. Viewing sFlow
destination information on page 168 is an Example: of sflow agent information.
Syntax:
show sflow agent
Displays sFlow agent information. The agent address is normally the IP address of the first VLAN configured.
The show sflow agent command displays read-only switch agent information. The version information shows
the sFlow version, MIB support, and software versions; the agent address is typically the IP address of the first
VLAN configured on the switch.
Viewing sflow agent information
switch# show sflow agent
Version 1.3;HP;XX.11.40
Agent Address 10.0.10.228
Syntax:
show sflow <receiver instance> destination
Displays information about the management station to which the sFlow sampling-polling data is sent.
The show sflow instance destination command includes information about the management-station's
destination address, receiver port, and owner, as shown in Viewing sFlow destination information on page
168.
Viewing sFlow destination information
switch# show sflow 2 destination
Destination Instance 2
sflow Enabled
Datagrams Sent 221
Destination Address 10.0.10.41
Receiver Port 6343
Owner Administrator, CLI-owned, Instance 2
Timeout (seconds) 99995530
Max Datagram Size 1400
Datagram Version Support 5
Note the following details:
• Destination Address remains blank unless it has been configured.
• Datagrams Sent shows the number of datagrams sent by the switch agent to the management station since
the switch agent was last enabled.
• Timeout displays the number of seconds remaining before the switch agent will automatically disable sFlow
(this is set by the management station and decrements with time).
• Max Datagram Size shows the currently set value (typically a default value, but this can also be set by the
management station).
168 Aruba 2530 Management and Configuration Guide for
ArubaOS-Switch 16.05
To Next Page