Aruba 2530 - LED Behavior During Connectivity Loss; Aruba Central Configuration Manually; Aruba-Central

• reboot
• restore
• menu
• write memory
• amp-server
LED behavior during connectivity loss
For the 2530, the FDX LED does not blink. It remains on during connectivity loss.
Aruba Central Configuration manually
In factory default switches, ZTP with Central is turned ON. ZTP can be disabled in the following scenarios:
• Switches with edited configuration
• Switches where the administrator has explicitly turned off ZTP with Central
In any of the mentioned scenarios, an administrator can manually configure Aruba Central using the aruba-
central command.
aruba-central
Syntax
aruba-central {enable | disable | support-mode {enable | disable}}
Description
Configure Aruba Central server support. When enabled, and when a server web address has been obtained using
Aruba Activate, the system will connect to an Aruba Central server. The system will obtain configuration updates
and most local configuration commands will be disabled. This mode is enabled by default.
Enter support mode to enable all configuration commands. Normally, when the system is connected to an Aruba
Central server, the configuration is updated from that server and most local configuration commands are disabled.
Support mode enables those commands for use in troubleshooting problems. Support mode is disabled by
default. When the system is not connected to Aruba Central server, the full command set is enabled for local
configuration.
Restrictions
• Switch communication to Aruba Central is not supported via OOBM.
• Aruba-central is not supported in FIPS switches and it will be disabled by default.
• Aruba-central is not supported in Stack switches and it will be disabled by default.
CAUTION: To avoid broadcast storm or loops in your network while configuring ZTP, do not have
redundant links after you complete ZTP and Airwave registration. Authorize the new switch and then
push the Golden Configuration template from Airwave.
Example
Enable Aruba Central server support
switch(config)# aruba-central enable
Chapter 10 Zero Touch Provisioning with AirWave and Central 241