Aruba 2530 - Viewing Switch Information Available for Outbound Advertisements

A civic address configuration
switch(config)# lldp config 2 medportlocation civic-addr US 2 1 CA 3
Widgitville 6 Main 19 1433 26 Suite_4—N 27 4 28 N4—3
switch(config)# show lldp config 2
LLDP Port Configuration Detail
Port : A2
AdminStatus [Tx_Rx] : Tx_Rx
NotificationEnabled [False] : False
Med Topology Trap Enabled [False] : False
Country Name : US
What : 2
Ca-Type : 1
Ca-Length : 2
Ca-Value : CA
Ca-Type : 3
Ca-Length : 11
Ca-Value : Widgitville
Ca-Type : 6
Ca-Length : 4
Ca-Value : Main
Ca-Type : 19
Ca-Length : 4
Ca-Value : 1433
Ca-Type : 26
Ca-Length : 9
Ca-Value : Suite_4-N
Ca-Type : 27
Ca-Length : 1
Ca-Value : 4
Ca-Type : 28
Ca-Length : 4
Ca-Value : N4-3
Viewing switch information available for outbound advertisements
Syntax:
show lldp info local-device [port-list]
Without the [port-list] option, displays the global switch information and the per-port information currently
available for populating outbound LLDP advertisements.
With the [port-list] option, displays only the following port-specific information that is currently available for
outbound LLDP advertisements on the specified ports:
• PortType
• PortId
• PortDesc
NOTE: This command displays the information available on the switch. Use the lldp config
<port-list> command to change the selection of information that is included in actual outbound
advertisements. In the default LLDP configuration, all information displayed by this command is
transmitted in outbound advertisements.
196 Aruba 2530 Management and Configuration Guide for
ArubaOS-Switch 16.05