Aruba 2530 - Configuring (Enabling or Disabling) the Timep Mode

Time Server Address : 10.10.28.100
Priority SNTP Server Address Protocol Version
-------- ---------------------------------------------- ----------------
1 10.10..28.101 3
2 10.255.5.24 3
3 fe80::123%vlan10 3
Default Gateway : 10.0.9.80
VLAN Name MAC Address | IP Address
------------ ------------------- + -------------------
DEFAULT_VLAN 001279-88a100 | 10.30.248.184
VLAN10 001279-88a100 | 10.0.10.17
Configuring (enabling or disabling) the TimeP mode
Enabling the TimeP mode means to configure it for either broadcast or unicast mode. Remember to run TimeP as
the switch's time synchronization protocol, you must also select TimeP as the time synchronization method by
using the CLI timesync command (or the menu interface Time Sync Method parameter.
Syntax:
timesync timep
Selects TimeP as the time synchronization method.
Syntax:
ip timep {<dhcp | manual>}
Enables the selected TimeP mode.
Syntax:
[no] ip timep
Disables the TimeP mode.
Syntax:
[no] timesync
Disables the time protocol.
Enabling TimeP in manual mode (CLI)
Like DHCP mode, configuring TimeP for manual mode enables TimeP. However, for manual operation, you must
also specify the IP address of the TimeP server. (The switch allows only one TimeP server.)
Syntax:
timesync timep
Selects TimeP.
Syntax:
ip timep manual <ip-addr>
Activates TimeP in manual mode with a specified TimeP server.
34 Aruba 2530 Management and Configuration Guide for
ArubaOS-Switch 16.05