Aruba 2530 - Page 35

Syntax:
no ip timep
Disables TimeP.
Enabling TimeP in DHCP Mode
Because the switch provides a TimeP polling interval (default:720 minutes), you need only these two commands
for a minimal TimeP DHCP configuration:
Syntax:
timesync timep
Selects TimeP as the time synchronization method.
Syntax:
ip timep dhcp
Configures DHCP as the TimeP mode.
For example, suppose:
• Time Synchronization is configured for SNTP.
• You want to:
◦ View the current time synchronization.
◦ Select TimeP as the synchronization mode.
◦ Enable TimeP for DHCP mode.
◦ View the TimeP configuration.
Enabling TimeP in Manual Mode
Like DHCP mode, configuring TimeP for Manual Mode enables TimeP. However, for manual operation, you must
also specify the IP address of the TimeP server. (The switch allows only one TimeP server.) To enable the TimeP
protocol:
Syntax:
timesync timep
Selects TimeP.
Syntax:
ip timep manual <ip-addr>
Activates TimeP in manual mode with a specified TimeP server.
Syntax:
[no] ip timep
Disables TimeP.
Chapter 2 Time Protocols 35