Aruba 2530 - Page 28

Syntax:
[no] sntp server priority < 1-3 > < ip-address > [version]
Use the no version of the command to disable SNTP.
priority
Specifies the order in which the configured SNTP servers are polled for the time.
ip-address
An IPv4 or IPv6 address of an SNTP server.
version
The protocol version of the SNTP server. Allowable values are 1 through 7; default is 3.
Syntax:
no sntp server priority <1-3> <ip-addr>
Deletes the specified SNTP server.
NOTE:
priority <1-3>
value must match what server is configured with. Deleting an SNTP server when only one is
configured disables SNTP unicast operation.
Example:
To select SNTP and configure it with unicast mode and an SNTP server at 10.28.227.141 with the default server
version (3) and default poll interval (720 seconds):
switch(config)# timesync sntp
Selects SNTP.
switch(config)# sntp unicast
Activates SNTP in unicast mode.
switch(config)# sntp server priority 1 10.28.227.141
Specifies the SNTP server and accepts the current SNTP server version (default: 3).
Configuring SNTP for unicast operation
switch(config)# show sntp
SNTP Configuration
Time Sync Mode: Sntp
SNTP Mode : Unicast
Poll Interval (sec) [720] : 720
Priority SNTP Server Address Protocol Version
-------- ---------------------------------------------- ----------------
1 2001:db8::215:60ff:fe79:8980 7
2 10.255.5.24 3
3 fe80::123%vlan10 3
28 Aruba 2530 Management and Configuration Guide for
ArubaOS-Switch 16.05