Aruba 2530 - Page 366

The logging command with a control description
switch(config)# logging 10.10.10.2 control-descr syslog_one
Adding a priority description
This description can be added with the CLI or SNMP. The CLI command is:
Syntax:
logging priority-descr <text_string>
no logging priority-descr
Provides a user-friendly description for the combined filter values of severity and system module. If no
description is entered, this is blank.
If text_string contains white space, use quotes around the string.
Use the no form of the command to remove the description.
Limit: 255 characters
The logging command with a priority description
switch(config)# logging priority-descr severe-pri
NOTE:
A notification is sent to the SNMP agent if there are any changes to the syslog parameters, either
through the CLI or with SNMP.
Configuring the severity level for Event Log messages sent to a syslog
server
Event Log messages are entered with one of the following severity levels (from highest to lowest):
Major
A fatal error condition has occurred on the switch.
Error
An error condition has occurred on the switch.
Warning
A switch service has behaved unexpectedly.
Information
Information on a normal switch event.
Debug
Reserved for HPE switch internal diagnostic information.
Using the logging severity command, you can select a set of Event Log messages according to their
severity level and send them to a syslog server. Messages of the selected and higher severity will be sent. To
configure a syslog server, see
Configuring a syslog server on page 358.
Syntax:
[no] logging severity {< major | error | warning | info | debug >}
Configures the switch to send all Event Log messages with a severity level equal to or higher than the specified
value to all configured Syslog servers.
366 Aruba 2530 Management and Configuration Guide for
ArubaOS-Switch 16.05