3. Because the OS file is large, you can increase the speed of the download by changing the switch console and
terminal emulator baud rates to a high speed. For Example:
a. Change the switch baud rate to 115,200 Bps.
=> sp 115200
b. Change the terminal emulator baud rate to match the switch speed:
I. In HyperTerminal, select Call|Disconnect.
II. Select File|Properties.
III. Click on Configure.
IV. Change the baud rate to 115200.
V. Click on [OK], then in the next window, click on [OK] again.
VI. Select Call|Connect.
VII. Press [Enter] one or more times to display the => prompt.
4. Start the Console Download utility by entering do at the =prompt and pressing [Enter]:
=> do
5. You then see this prompt:
You have invoked the console download utility.
Do you wish to continue? (Y/N)>_
6. At the above prompt:
a. Enter y (for Yes)
b. Select Transfer|File in HyperTerminal.
c. Enter the appropriate filename and path for the OS image.
d. Select the Xmodem protocol (and not the 1k Xmodem protocol).
e. Click on [Send].
382 Aruba 2530 Management and Configuration Guide for
ArubaOS-Switch 16.05
To Next Page
Loading...
