Job Status : Enabled
Running Status : Active
Run Count : 0
Error Count : 0
Skip Count : 0
Command : cfg_rollback
switch(config)# show cfg-restore status
Status : Success
Config File Name : stable
Source : Flash
Time Taken : 9 Seconds
Last Run : Tue Nov 28 20:50:00 2017
Recovery Mode : Enabled
Failure Reason : -
Number of Add Commands : 27
Number of Remove Commands : 0
Time Taken for Each Phase :
Calculating diff : 4 Seconds
Adding commands : 1 Seconds
Removing commands : 0 Seconds
NOTE: If the configuration involves any sensitive information, backup and restore the
configuration by enabling the include-credentials command.
Commands used in switch configuration restore without
reboot
cfg-backup
Backs up the selected configuration to the flash file.
show config files details
Shows a detailed list of configuration files available in the flash.
cfg-restore
Restores the given configuration as the running configuration without reboot.
show cfg-restore status
Shows the status of latest restore performed.
show cfg-restore latest-diff
Views the list of configuration changes that are removed, modified, or added to the running configuration.
show hash
Shows the SHA ID of a startup or running configuration.
Configuration backup
The configuration backup creates a backup of the running or startup configuration of ArubaOS-Switch on-demand
to the flash storage on the switch. The maximum number of backup files supported has increased from three to
five.
Chapter 20 Configuration backup and restore without reboot 401
To Next Page
Loading...
