CAUTION:
Disabling the diagnostic reset prevents the switch from capturing diagnostic data on those rare
events where the switch becomes unresponsive to user input because of unknown reasons. Ensure
that you are familiar with the front panel security options before proceeding.
Show front-panel-security
Syntax
show front-panel-security
Options
Show front-panel-security
Clear Password - Enabled
Reset –on-clear - Disabled
Factory Reset - Enabled
Password Recovery - Enabled
Diagnostic Reset - Enabled
NOTE:
By default, user initiated diagnostic reset is enabled.
Diagnostic table
Validation rules
Validation Error
Extra ‘token’ passed after diagnostic-reset. Invalid input: <token>.
FPS Error Log
Event Message
RMON_BOOT_CRASH_RECORD1 Diagnostic reset sequence detected on serial
console; user has initiated diagnostic reset.
On detection on local serial
RMON_BOOT_CRASH_RECORD1 SMM: Diagnostic reset sequence detected
on serial console; user has initiated
diagnostic reset.
On detection on SMM serial console and
signaled to AMM
Table Continued
Chapter 21 Virtual Technician 425
To Next Page
Loading...
