Aruba 2530 - Page 52

Validation Error/Warning/Prompt
If timeSync is in SNTP or Timep when NTP
is enabled.
Timesync is not configured to NTP.
If timesync is NTP and NTP is enabled and
we try to change timesync to SNTP.
Disable NTP before changing timesync to SNTP or
TIMEP.
If we try to configure NTP servers more than
the configured max-associations value.
The maximum number of NTP servers allowed is 2.
If we have ‘n’ NTP servers configured and
we try to configure a max-associations value
less than (n) number of NTP servers already
configured.
Max-associations value cannot be less than the
number of NTP servers configured.
If authentication key-id is not configured. Authentication key-id %d has not been configured.
If key-id is not marked as trusted. Key-id %d is not trusted.
If min poll value is more than max poll value. NTP max poll value should be more than min poll
value.
If ipv6 is not enabled on vlan interface. IPv6 address not configured on the VLAN.
52 Aruba 2530 Management and Configuration Guide for
ArubaOS-Switch 16.05