Z100-TYPE HARDWARE
Installing Z100-Type Hardware at Satellite Locations
To install the Z100A1 connector modules at the satellite location, use the same installation
procedure described under the heading Installing the Cross-Connect Field. Figure 2-65
shows a typical satellite location installation.
NOTES:
1.
EACH CONNECTOR MODULE AND THE Z9A
SUPPORT IS 5 INCHES (12.7 CM) WIDE.
2.
THIS DISTANCE IS FROM THE FLOOR TO
THE BOTTOM OF THE Z9A SUPPORT
Figure 2-65. Typical Satellite Installation
As shown in Figure 2-66, 3-pair station circuits connect to the bottom three connecting units
(white field). Four-pair station circuits connect to the top four connecting units (blue field).
2-92
To Next Page
Loading...