110-TYPE HARDWARE
110P-Type Hardware
The 110P-type hardware consists of 100-pair wiring terminals separated by horizontal patch
cord troughs mounted on a back panel. The P-type hardware is available in 300- and 900-
pair field-terminated and connectorized terminal blocks. The 110P-type terminal blocks are
made up of alternate rows of 110-type wiring blocks and horizontal jumper troughs arranged
in a vertical column with the troughs located above the wiring blocks. At the bottom of the
terminal block is a partially closed duct. The field-terminated hardware must be assembled
(troughs and wiring blocks must be fastened to the back panel); the connectorized terminals
come fully assembled and ready for mounting. The 300-pair connectorized terminal block is
shown in Figure 3-6.
There are two types of 900-pair connectorized terminal blocks: one has a connector field at
the top; the other is connectorized with a 40-inch length of cable terminated with a female
25-pair cable at the bottom (see Figures 3-7 and 3-8).
3-9
To Next Page
Loading...