110-TYPE HARDWARE
F Clip Terminal Insulator
The F Clip Terminal Insulator (AT-8660F) is used to identify special circuits. Each insulator
identifies one pair and may be located in adjacent pair positions without interference.
F CLIP TERMINAL INSULATOR ORDERING INFORMATION
Description
Comcode
F Clip Terminal Insulator
401 149 802
Designation Strips
The designation strips are made of clear plastic and snap into alternate rows of the 110-type
wiring block to identify cable pairs and to conceal the cable conductors. Each designation
strip can be used to identify 50-pairs of wire. The designation strips accept the standard
110-labels ordered separately. The designation strips are shipped with the no-type terminal
blocks.
ASSOCIATED HARDWARE
Cable Slack Managers
General
The cable slack managers (Figure 3-11) are raised floor units 32 inches (81.3 cm) wide,
38 inches (96.5 cm) deep, and 4.5 inches (11.4 cm) high. The cable slack managers are used
for cable distribution and cable slack storage between the system cabinets and the cross-
connect field. They can also accommodate a limited amount of slack in station cables.
Power cables from the switch and auxiliary cabinet are also run through the managers. They
are recommended for use with the system (instead of overhead cable racks).
Note: Cable slack managers are not required when the switch cabinet is installed on a
raised computer floor. The station cabling and the cabling from the system cabinets is
routed under the computer flooring to the cross-connect field.
The managers have tabs and interlocks that allow adjacent cable slack managers to interlock
together. Retainers mounted on columns inside the cable slack manager keep the cables
from protruding above the top of the base. The cable slack managers are coded as housings
and are available as follows.
Z113A Housing
The Z113A housing is used between the wall and equipment cabinets (Switch, Applications
Processor, Auxiliary, etc.). It consists of a Z8A1 base, 2 Z814A covers, and 25 Z6A retainers.
Z114A Housing
The Z114A housing is designed to be used adjacent to the Z113A housing if no equipment
cabinet exists at the position or if the cabinet(s) is positioned against the wall with the
cross-connect field beside the cabinet(s). It consists of a Z8A1 base, 1 Z814A cover, 1 Z815A
cover, and 25 Z6A retainers.
3-19
To Next Page
Loading...