Z100-TYPE HARDWARE
Figure 2-66. Satellite Location Layout
Labeling
Figure 2-66 shows the fill direction for the blue and white fields at the satellite location.
The labels are numbered sequentially starting at number 1. A satellite symbol label is
placed at the top of the first connector module and the Z9A support at the end of the field to
identify the satellite location.
Figure 2-67 shows the station wiring labeling scheme from the white field at the equipment
room to the information outlet. In the example shown, the white label identifying
connecting unit jack positions 17 through 24 is connected to an identically labeled connecting
unit at the satellite location. This is always the case for either 1-point or 2-point
administration. See PATCH CORD INSTALLATION AND ADMINISTRATION for
details.
The satellite symbol label must be installed at the connector module and at all connection
points between the blue field and the information outlet. It must also be installed at the
information outlet itself.
2-93
To Next Page
Loading...