66-TYPE HARDWARE
Tools
The following tools are required to terminate or remove the wire on the connecting blocks:
●
The 714B Tool is a nonimpact single-wire termination tool
●
The D Impact Tool (AT-8762) is a single-wire termination tool
●
The 724A Tool is used to remove wires from the connecting blocks.
66-TYPE TOOLS ORDERING INFORMATION
Description Comcode
714B Tool 100 755 511
Blade AT-8762D-66 402 024 681
D Impact Tool 402 024 723
724A Tool xxx xxx xxx
Bridging Clips
Bridging Clips are spring clips used to connect two adjacent terminals in the same row of
the connecting blocks. The bridging clips provide the fastest and most reliable way to make
cross-connections. No special tools are required to install or remove the clips.
BRIDGING CLIPS ORDERING INFORMATION
Description
Comcode
BCSS-2 Bridging Clip
403 596 035
ASSOCIATED HARDWARE
Cable Slack Managers
General
The cable slack managers (Figure 4-7) are raised floor units 32 inches (81.3 cm) wide,
38 inches (96.5 cm) deep, and 4.5 inches (11.4 cm) high. The cable slack managers are used
for cable distribution and cable slack storage between the system cabinets and the cross-
connect field. They can also accommodate a limited amount of slack in station cables.
Power cables from the switch and auxiliary cabinet are also run through the cable slack
managers. They are recommended for use with the system (instead of overhead cable racks).
Note: Cable slack managers are not required when the switch cabinet is installed on a
raised computer floor. The station cabling and the cabling from the system cabinets is
routed under the computer flooring to the cross-connect field.
The cable slack managers have tabs and interlocks that allow adjacent cable slack managers
to interlock together. Retainers mounted on columns inside the cable slack manager keep
4-11
To Next Page
Loading...