66-TYPE HARDWARE
Installing Selector Console
Requirements
The selector console is connected to the attendant console by a 3-foot (91-cm) D8AC cord
provided with the selector console (see Figure 4-58).
Installation
1.
2.
3.
Run and connect 3-foot (91-cm) D8AC cord between DXS/BLF jack on bottom of
attendant console and modular jack on bottom of selector console.
Note: These jacks are located on the bottom of the consoles.
Install labels per Attendant Console Form.
Administer per AT&T System 75 and System 75 XE Implementation and AT&T
System 75 and System 75 XE Administration.
Figure 4-58. Selector Console Installation
4-90
To Next Page
Loading...