AT&T 75 - Jumpers; Test Cords; Tools

110-TYPE HARDWARE
Test Cords
The D Test Cord (4- or 8-foot) provides test access to one pair of wires without removing any
jumpers.
D TEST CORD ORDERING INFORMATION
Cord Length
Comcode
D Test Cord
4 ft (1.2 m)
402 023 949
D Test Cord 8 ft (2.3 m)
402 023 956
Jumpers
Jumpers of solid wire can be used for cross-connections instead of the 1- and 3-pair patch
cords. The jumpers can be terminated on the connecting blocks using an impact tool.
JUMPER WIRE ORDERING INFORMATION
Jumper Wire
Description
Comcode
(Order by Footage)
DT 24M-Y/BL/R/G 2-Pair
103 252 557
DT 24P-W/BRN
1-Pair
102 484 045
DT 24P-Y/BL 1-Pair
102 379 195
DT 24P-Y/G
1-Pair
103 252 565
DT 24P-Y/O
1-Pair
103 252 573
DT 24P-Y/R 1-Pair
103 252 581
Tools
The following tools are required to terminate the wire on the connecting blocks if field-
terminated connecting blocks or jumpers are used:
● The D Impact Tool (AT-8762) is a single-wire termination tool
● The 788J1 Impact Tool is used to terminate five pairs of wire
● The 788 K1 Conductor Retention Tool is used to hold down cable pairs during
removal of the connecting blocks.
110-TYPE TOOLS ORDERING INFORMATION
Description
Comcode
D Impact Tool 402 024 723
788J1 Impact Tool 102 648 839
788 K1 Conductor Retention Tool 102 655 495
3-18