Z100-TYPE HARDWARE
The yellow/blue label is used on 25-pair station cables that connect to site or satellite
closets.
LABEL NAME
RANGE
PORT CABLE
1A1-1A10, 1B1-1B20,
1C1-1C20, 1D1-1D20,
1E1-1E20
BUILDING
FIELD IDENTIFIED
FLOOR
FIELD IDENTIFIED
SAMPLE LABEL
PURPLE
BLUE/YELLOW
AUXILIARY
CABLE
FIELD IDENTIFIED
YELLOW
SITE OR
A-F AND/OR
SATELLITE
FIELD IDENTIFIED
BLUE/YELLOW
Figure 2-41. Equipment Room Cabling Labels
CABLE/JACK/BUILDING LABEL ORDERING INFORMATION
Figure 2-42 shows the proper label installation on a 25-pair cable connector (see Note).
Note: The label should be installed near the rear of the connector as shown so that it
Description Qty. Per Code
Comcode
201A Labels
34 sheets
103 969 994
will not be obscured by any of the switch cabinet, cable access panel, or connector
module connector retainers. It can also be installed on the skin of the cable near the
connector.
Figure 2-42. Self-Stick Label Installation on 25-Pair Cable Connector
Routing Cable Guidelines
The following guidelines should be followed when installing the equipment room cabling.
Following these guidelines will make optimum use of the cable slack managers and make
future cabling additions and changes easier.
2-61
To Next Page
Loading...