AT&T 75 - Installing INADS (Initialization and Administration System) Interface

Z100-TYPE HARDWARE
Installing INADS (Initialization and Administration System) Interface
Requirements
The Initialization and Administration System (INADS) trunk should be specified to appear
on the twenty-fifth pair of an RJ21X network interface jack. The INADS trunk must be a
two-way, rotary dial, loop start trunk. The INADS trunk is connected to the TN731
Maintenance circuit pack through the cable access panel. This connection is made at the
INADS terminals. Figure 2-81 shows a typical INADS trunk installation.
Installation
1.
2.
3.
Determine INADS trunk appearance at cable access panel.
Install jumpers between INADS trunk appearance (IN) and INADS terminals.
Label terminals for INADS trunk appearance (IN).
2-112