Z100-TYPE HARDWARE
Connecting Units
The four connecting units (Figure 2-6) that can be used in the connector modules are as
follows:
● Z200A1—Used for connectorized station cables (4-pair station circuits from
equipment room or satellite locations).
●
Z201A1—Used in the cross-connect field for the connectorized switch cables and in
satellite locations for connectorized station cables (3-pair station circuits from the
equipment room).
●
Z202A1—Used for Standard Serial Interface (SSI) port circuits from an Applications
Processor (AP) to data terminals only.
●
Z203A1—Used for connectorized station cables (3-pair station circuits from the
equipment room).
The Z202A1 connecting unit is not available in the preassembled connector modules. It can
be used as a replacement in the Z100A1 or Z100B1 connector modules. Figures 2-7 and 2-8
show how the connecting units are installed and removed.
CONNECTING UNIT ORDERING INFORMATION
Description
Comcode
Z200A1 Connecting Unit
103 961 256
Z201A1 Connecting Unit
103 961 264
Z202A1 Connecting Unit
103 961 272
Z203A1 Connecting Unit
103 961 280
2-7
To Next Page
Loading...