AT&T 75 - Page 18

Installing Cables Between Switch Cabinet and the Cross-Connect
Field
Installing Cables Between Cross-Connect Field and Auxiliary
Cabinet
STATION WIRING DESIGN
Description
Information Outlets
Station Cables
Closets
Site Locations
Satellite Locations
Station Circuit Distribution From Equipment Room
4-Pair Station Circuits
3-Pair to 4-Pair Station Circuits
Layout
Locating Information Outlets
Locating Satellites and Sites
Adapter Requirements
Z100A1 Connector Module Requirements
Sizing 4-Pair Station Cables (DIW)
Sizing 25-Pair and Multiple 25-Pair Station Cables
3-Pair Station Cable Circuits
4-Pair Station Cable Circuits
STATION WIRING AND ASSOCIATED HARDWARE INSTALLATION
Installing the Station Cables
Installing Z100-Type Hardware at Satellite Locations
Labeling
Installing the Information Outlets
ADJUNCT POWERING
Adjunct Powering From the Equipment Room
Adjunct Powering From Satellite Locations
Adjunct Powering From Site Locations
Adjunct Powering From Information Outlets
PATCH CORD INSTALLATION AND ADMINISTRATION
Equipment Room Cross-Connect Field
Installing Patch Cords
Removing Patch Cords
2-74
2-78
2-78
2-78
2-78
2-78
2-80
2-80
2-82
2-83
2-83
2-83
2-88
2-88
2-88
2-88
2-88
2-88
2-88
2-88
2-89
2-89
2-89
2-92
2-93
2-95
2-96
2-96
2-96
2-96
2-100
2-102
2-105
2-105
2-105
-iii-