110-TYPE HARDWARE
1.
2.
3.
Connect B25A cables between the network interface and the sneak fuse panels.
Connect A25D cables from the sneak fuse panels to the 110 terminal block
connectors in the green field.
Connect 1-pair patch cords or jumper wires from each green 110 terminal block
row to the purple and yellow 110 terminal block rows as shown by the example in
Figure 3-68 for 1-pair central office trunks or by the example in Figure 3-69 for 3-
pair tie trunks.
Figure 3-68. Example of Establishing 3-Pair Modularity for Trunk Pairs Used
for 1-Pair Trunk Circuits; DID, Loop Start, Ground Start
3-92
To Next Page
Loading...