• The obstacles spring open automatically in the event of a mains loss > 150 ms.
- Before working on the mechanism, check that the obstacles are open.
• Any internal component likely to be energized or in movement must be handled with caution.
• The use of gloves or antistatic wristbands (Electronic Static Discharge) is essential when handling electronic circuit boards,
otherwise the warranty may be voided.
• The equipment is configured in minimal risk mode for its users. Any modification of the settings must be carried out with
full knowledge of the all the considerations involved by qualified personnel and Automatic Systems accepts no liability for
such modification.
• In the event of resale of the product, it is the responsibility of the reseller to ensure, when offering, selling and installing
each piece of equipment, that the environment and foreseeable use of the equipment take into account the technical
characteristics of the equipment and respect these prescriptions.
• The seller shall defend and indemnify Automatic Systems from any claims against Automatic Systems due to the seller’s
failure to comply with the above obligations.
• For any operation that does not require the motor or logic to be powered up, cut the power supply before opening the
bodywork.
• Otherwise, disconnect the power supply by means of the circuit breaker located on the electrical board of the device
( Ref. 20, Chap. 4.7).
9
SmartLane
To Next Page
Loading...
