Avaya DEFINITY ONE - Install DEFINITY ONE Main Distribution Frame (MDF) and External Modem; Install the MDF on DEFINITY ONE

Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10
555-233-109
Issue 6
December 2001
Install and Cable the Cabinet
1-77Install DEFINITY ONE main distribution frame (MDF) and external modem
1
Install DEFINITY ONE main
distribution frame
(MDF) and external modem
Install the MDF on DEFINITY ONE
!
WARNING:
The optional MDF is a special 110 cross-connect field that is smaller than the standard
110 cross-connect hardware. Do not install standard 110 hardware inside the right
panel.
NOTE:
The depth of any equipment installed inside the right panel must not exceed 2.5 inches
(6.3 cm), or the right cover panel will not fit over the right panel.
The optional MDF represents the trunk/auxiliary field.
■ Mount the optional MDF to the right panel using the following procedure:
Bottom-mounted MDF with modem
1. On the rear of the MDF, cut the cable tie securing the top 5 cables to the
MDF mounting frame.
2. Mount the MDF to the right panel. See Figure 1-40 on page 1-78.
3. Secure all 10 cables to the bottom left bracket on the MDF with a cable tie.