Avaya DEFINITY ONE - Copy the Firmware Image to Source Board

Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10
555-233-109
Issue 6
December 2001
Hardware Additions
6-12Downloading Firmware to Port Circuit Packs
6
Copy the firmware image to source board
The source board is the TN799DP Control Lan (C-LAN) circuit pack. You use an
FTP program on a PC to download the files to the source board.
You’ll need the IP address for the source board, which you can get from your data
systems administrator or by typing the following series of commands:
1. list configuration board
UUCSS to make sure the port is enabled (look
for the number 17).
2. display port
UUCSS 17 to obtain the data module ID.
3. display data-module
ID to obtain the link number.
4. status link
link_number to check the link status and obtain the source IP
address.
You can use any FTP program. The following steps are generic to most FTP
programs. Please follow the instructions for your specific program.
■ Using an MS-DOS or UNIX FTP program
■ Using a GUI-based FTP program
Using an MS-DOS or UNIX FTP program
1. Type ping source_ip_address and press Enter to verify a communication
link to the source board.
2. Type ftp
source_ip_address and press Enter.
3. Log in using the user ID and password that you created at the time you
created the file system.
4. Type bin and press
Enter, which enables older ftp programs to send binary
files.
5. Type put
filename to copy the file to the source board.
6. Type dir to verify that the file is on the source board.
7. Repeat steps 5 and 6 for each file.
8. Type quit and press
Enter to end the ftp session.